Some Assembly Required.

 In most cases and depending on which model purchased, it usually takes anywhere from 30 to 90 minutes to complete the assembly process of your vehicle. Our vehicles are usually 80% assembled at the factory and fully tested prior to shipping.To complete the assembly of your vehicle, you will need to properly install and/or assemble the contents included with your vehicle. Depending on the model purchased, these items are usually located in the storage compartment underneath the seat. For your safety, be sure to check and tighten all screws, nuts, and bolts prior to using your vehicle for the very first time and periodically thereafter. Depending on the length of time the scooter has been stored in the crate after factory testing, the carburetor may need to be cleaned due to possible sediment build-up. Detailed instructions on how to perform this procedure can be obtained by contacting our technical support team. Local pick-ups and optional assembly service is available upon request. 

Remember!

You are responsible for performing the setup and PDI (Pre-Delivery Inspection) that a dealer would normally perform (ie. installing rear view mirrors, setting up and connecting the battery, checking tightness of all screws, nuts, bolts, changing oil, valve adjustment etc.). In some instances, it may be necessary for your vehicle to be setup and tuned by a local service center. Items such as loose hardware and parts damaged from loose hardware and components are not covered under warranty. It is advisable to use a thread locking agent such as Loctite on all hardware to help prevent loss of hardware. Occasionally, on some units, it may be necessary to perform other routine checks or adjustments, such as adjusting the setting of the idle speed and fuel/air mixture screws on the carburetor, cleaning of the carburetor, checking to ensure wires are connected properly, adjusting chain slack and alignment (if applicable), in order to achieve optimum performance from your vehicle. We will gladly assist you with any additional technical questions you may have.

Prior to first use, it is mandatory to have the existing motor/engine oil (known as “packing oil”) replaced. The packing oil should be replaced with conventional four-stroke “Motorcycle Grade” (SAE 10W-40) engine/motor oil. Be sure to regularly inspect engine fluid levels to ensure that your vehicle operates safely according to manufacturer’s recommended specifications.
 

Specifications